Felt replacement skills of the hottest glass cutti

2022-09-20
  • Detail

Glass cutting table felt replacement skills

instructions for replacing the black felt on the top of the air flotation table of the glass upper and lower cutting table

1. First of all: tear off the original broken and unusable felt, and then polish and flatten the glue traces left on the table, take a piece of black felt dedicated to the top of the glass upper and lower cutting table of Beifang Zeyuan felt, and then prepare the special glue and apply the glue on the table, The upper and lower pieces of glass with Beifang Zeyuan felt can be used with special black felt on the cutting table top

2. The working principle of the black felt on the top of the floating table of the upper and lower glass cutting table

1. The glass upper table felt is used for the table mat of the glass cutting table/turnover table, replacing the traditional wool felt and floor felt. The debris generated during glass cutting will not be embedded in the table mat, which is easy to remove and protect the glass from being scratched. It can completely replace imported products

2. Material: needle punched with high-strength synthetic fiber. Excellent mechanical properties, fiber is not easy to break, wear-resistant, aging resistant, no fuzzing. The elasticity and toughness of the felt can be maintained after long-term use

3. The black wool on the top of the air flotation table of the glass upper and lower cutting table is easy to be weathered. The felt and the maintenance method of the machine

1. The screws on the fan base and the connecting screws between the walking motor and the reducer shall be rechecked once every 6 months

2. Clean the felt on the table once a day after use. It is recommended that the special felt on the table of Zeyuan felt cutting table be replaced once a year

3. Replace the remote control battery every 6 months

4. The bearings at both ends of the turnover arm, the driving wheel at both ends of the driving wheel, the bearings at both ends of the driven wheel, the sheet breaking movable rod, the universal wheel, the directional wheel and the relevant movable parts are added once a month and a half to evaluate the heat sealing strength at the fixed sealing position of the packaging bag film 1

5. Electrical control box terminals shall be rechecked once every 6 months

6. The locking sleeve of the four connecting rods of the turnover arm shall be rechecked once every three months to prevent loosening

7. Suction resolution: 1/200000, displacement accuracy: ± 1% If glass slag or other impurities are found in the groove in the plate, they should be cleaned immediately

8. If the air flotation effect is found to be reduced during the use of the equipment, it can be adjusted appropriately according to the total height of the table

9. Regularly check whether the pores on the table are blocked

10. Reset the thermal relay reset button every two months

Copyright © 2011 JIN SHI